阅读权限90
最后登录2023-12-19
在线时间89 小时
积分4686
注册时间2015-3-9
精华0
主题0
UID34232
帖子616
金币9663
威望0
贡献0
技术0
活跃1171
论坛贵宾VIP-永久权限
- 贡献
- 0
- 技术
- 0
- 活跃
- 1171
- 在线时间
- 89 小时
|
发表于 2015-4-7 14:13:22
|
显示全部楼层
PCI bus mb0_mb1 (Slots 0, 1, 3 and 5) has a capacity of 600 bandwidth points.
Current configuration on bus mb0_mb1 has a total of 600 bandwidth points.
This configuration is within the PCI bus capacity and is supported.
PCI bus mb2 (Slots 2, 4, 6) has a capacity of 600 bandwidth points.
Current configuration on bus mb2 has a total of 0 bandwidth points
This configuration is within the PCI bus capacity and is supported.
Please refer to the following document "Cisco 7200 Series Port Adaptor
Hardware Configuration Guidelines" on Cisco.com <http://www.cisco.com>
for c7200 bandwidth points oversubscription and usage guidelines.
3 FastEthernet interfaces
125K bytes of NVRAM.
65536K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
8192K bytes of Flash internal SIMM (Sector size 256K).
SETUP: new interface FastEthernet0/0 placed in "shutdown" state
SETUP: new interface FastEthernet1/0 placed in "shutdown" state
SETUP: new interface FastEthernet1/1 placed in "shutdown" state
% Crashinfo may not be recovered at bootflash:crashinfo
% This file system device reports an error
Press RETURN to get started!
|
|